RSS Feed
Knowledgebase : HYPACK > DREDGEPACK

This update allows the charts to be properly loaded in the report if they are enabled in the HYPACK Shell. 
The Bucket Log program is designed to generate a report for the mechanical dredge community. The program is written to read the ...
* Tells the operator how much material is above or below the template in the Matrix cell that the cutter tool is over * The ...
DREDGEPACK - SWINGIND.DLL DEVICE DRIVER * Measures angle of cutter tool relative to * Planned Survey Line (*.LNW) * Pare...
A user reported that DREDGEPACK crashes on exit and does not save any changes made while in the DREDGEPACK Program.  Investiga...
Most dredgers want to track what station the cutter head or spud is located at. To do so you will need to do the following:   ...
EXCAVATOR CALIBRATION - EXCAVATOR.DLL * Each piece of the Arm must be measured accuratly * Boom - Boom pin --> Boom to st...
RTK ON EXCAVATOR: * ON AN EXCAVATOR THAT IS USING AN RTK GPS FOR TIDE THERE ARE TWO DIFFERENT METHODS THAT CAN BE EMPLOYED. ...
EXCAVATOR.DLL - GENERAL SETTINGS TAB CONTAINS: ž žExcavator Dimensions ž žSystem Override Values žUseful when a sens...
The attached files are used in to send data to the DQM office for a HYDRAULIC ( CS ) dredge. The DQM_INC driver is placed into t...
HYPACK DQM FOR PIPELINE DREDGES   The United States Army Corps of Engineers will soon be requiring pipeline dredges over 18 ...
SET CUTTER TOOL TO WATER SURFACE AND ZERO OUT THE HEIGHT OF THE CUTTER TOOL. IF THE TOOL AND ITS CALIBRATION POINT CANNOT TOUCH ...
Inclinometer.dll does fails to load in DREDGEPACK   This can be caused by the Inclinometer.dll having a function of draft in...
Making a bucket switch to lay down BKT files in DREDGEPACK is simple. This momentary switch is wired and connected to a COM port...
PURPOSE OF THE MATRIX REPORTER * To provide a quick report of progress in any dredging environment. To allow the user to see...
    After being asked numerous times to design some new shapes to better represent the look of a crane when using the DQM Crane ...
You will need to have a copy of HYPACK installed on a compute in the office and have a HYPACK SURVEY key. You will then do the f...
As part of our tools for supporting our customers we are switching to Bomgar and away from the current Team Viewer system. The f...
Quite often we are asked to set up a dredge in an inland location where elevations are involved. The general problem is that the...
DISPLAYING STATIONING IN DREDGEPACK   It is possible to display Stationing or what we like to call "Chainaige" in DREDGEPACK...
DREDGEPACK® requires a filled MTX and cannot use the AutoMatrix option. * TIN MODEL can fill a blank matrix. * XYZ TO MTX ...
WHY DOESN'T MY CUTTER DREDGE PIVOT ON THE STERN SPUD?  We get this questions very often here in HYPACK support. It is a very e...
XML FILES - IMPORTING AND CONVERTING HYPACK has the ability to bring in XML files. XML files can be of collected survey data o...