Knowledgebase
Excavator Calibration - Excavator.dll
Posted by Christian Shaw, Last modified by
Notice
Undefined index: editedstaff (C:/inetpub/wwwroot/Support/__swift/cache/8ffb74eb8fb5aeb3f7fb2e375265078e.php:44)
Copy to clipboard:
on 26 January 2017 12:55 PM

Excavator Calibration - Excavator.dll

  1. Each piece of the Arm must be measured accuratly
    1. Boom - Boom pin --> Boom to stick pin
    2. Stick - Stick Pin --> Stick to bucket pin
    3. Bucket - Bucket pin --> Teeth --> With teeth plumb to bucket pin
  2. Enter each dimension in Excavator.dll "SETUP" Form

The next part of the caibraton is to measure the H1 and the X1 calibration offsets --> The calibrate button can be found in the Excavator.dll "SETUP" Form