Knowledgebase
Inclinometer.dll Calibration
Posted by Christian Shaw, Last modified by
Notice
Undefined index: editedstaff (C:/inetpub/wwwroot/Support/__swift/cache/8ffb74eb8fb5aeb3f7fb2e375265078e.php:44)
Copy to clipboard:
on 24 January 2017 09:08 AM

Set cutter tool to water surface and zero out the height of the cutter tool. If the tool and its calibration point cannot touch water, you can put a know offset in for the height

  • Angle calibration is seldom used as it takes an instrument to know angle of ladder relative to the water surface

Check your depth calibration

You dig calculated depth, make sure its correct!

The best way to verify if to take a tape measure out to your boat and tie off to cutter head. Lower to head to known depth and match up with what HYPACK shows in Data Display

  • Formula
  • Sin of the angle * Ladder Length