Sub Bottom Errors
Posted by Christian Shaw, Last modified by
Undefined index: editedstaff (C:/inetpub/wwwroot/Support/__swift/cache/8ffb74eb8fb5aeb3f7fb2e375265078e.php:44)
Copy to clipboard:
on 30 July 2015 01:55 PM

Recently came into a situation where the Subbottom Program failed and could only end through task manager. The problem was that there were several 0 kb seg-y files in the raw directory. When we first went to load up the whole data set the program would stop reading these files and render the program useless. 

We did the following to clear the error. 


1. Delete all of the 0 kb Seg-Y files

2. Delete the SBP.xml file in the project folder. 


After doing this , ALL the files were read into the program gracefully. The problem is that if you start a new Sub Bottom session with bad files, then the XML gets corrupt and you cannot proceed from here.